G-35
GR1600EC2, WSM
G GENERAL
[10] OTHERS
Replacing Fuses
1. Open the hood.
2. Remove the blown fuse.
3. Place a new 3 A or 10 A or 15 A or 30 A or 40 A fuse in position.
IMPORTANT
• Never "jump" the fuse with wire or foil, or install a larger
capacity fuse than is recommended.
■ Protected Circuit
W1023430
Replacing Bulbs
(A)Replacement of the head light bulb
1. Open the hood.
2. Turn bulb socket to remove socket from head light housing.
3. Push bulb down and turn one quarter turn to remove bulb from
the socket.
4. Install new bulb to the socket.
5. Install the socket in housing.
6. Close the hood.
(B)Replacement of the indicator light bulb
1. Open the hood.
2. Turn bad bulb socket to the left. And remove it.
3. Pull bulb from the socket.
4. Push new bulb into the socket.
5. Install the socket.
6. Close the hood.
W1023802
Fuse No. (ID Label) Capacity (A) Protected circuit
(1)
Engine Stop (a) 15 Engine stop timer relay
IG/M (b)10
Fuel pump, head light, power
steering control unit, etc.
OPC (c)3OPC
(2) –
Slow blow fuse
40
Check circuit against wrong
battery connection
(1) Fuse Location (2) Slow Blow Fuse
Head light bulb 24W
Indicator light bulb
14.0 rated voltage / 0.27
AMP/2 MSCP
To Next Page
