G-37
GR1600EC2, WSM
G GENERAL
Replacing Mower Belt
1. Remove the mower deck from the machine.
2. Remove the left and right hand shield (4), (6) from the mower
deck.
3. Clean around the pulleys to remove the belt (3) from the pulleys.
Slip the belt (3) over the top of the left side pulley.
4. Remove the both brackets which mounts the gear box to the
mower deck.
5. To install a new belt, reverse the above procedure.
W1073387
Bleeding Fuel System
Air must be removed :
1. When the fuel filter or lines are removed.
2. When tank is completely empty.
3. After the machine has not been used for a long period of time.
Bleeding procedure is as follows :
1. Fill the fuel tank with fuel.
2. Start the engine and run for about 30 seconds, and then stop the
engine.
W1074213
Tightening torque Bracket mounting screw
39.2 to 44.1 N·m
4.0 to 4.5 kgf·m
8.8 to 9.9 ft-lbs
(1) Bolt
(2) Bolt, Nut
(3) Belt
(4) Left Hand Shield
(5) Right Hand Shield
(6) Mower Gear Box
To Next Page
