64 / 85 Issued: 08.09.2015 Version: Spez KR 30, 60-2 JET V1
KR 30-2 JET; KR 60-2 JET
Dimensioned
drawing
The following illustration (>>> Fig. 6-2 ) provides all the necessary information
on the mounting base with bedplate, together with the required foundation da-
ta. To ensure that the anchor forces are safely transmitted to the foundation,
the specified dimensions for the concrete foundation must be observed. The
position of the individual foundations is order-specific; the necessary dimen-
sions can be found in the section “Order-specific technical data”.
Grade of concrete
for foundations
When producing foundations from concrete, observe the load-bearing capac-
ity of the ground and the country-specific construction regulations. There must
be no layers of insulation or screed between the bedplates and the concrete
Fig. 6-1: Mounting base, installation
1 Column, base plate 4 Bedplate
2 Fastening elements 5 Resin-bonded anchor
3 Weld-on plate 6 Leveling screw
Fig. 6-2: Mounting base, dimensioned drawing
1 Concrete foundation
2 Center of foundation
3 Bedplate
To Next Page
Loading...
