1-2
Front Panel
Front Panel Quick Reference
Soft Buttons
Functions change depending on current display page. Function of each button is displayed on
bottom line of display.
Exit Button
Press to leave various editors. If you’ve made any changes while in the editor, you will be
prompted to save them.
Cursor Buttons
Press the corresponding button to move the cursor up, down, left, or right in the display.
Different parameter values will be highlighted as buttons are pressed.
Alpha Wheel
For data entry. Rotate clockwise to increase value of currently selected parameter,
counterclockwise to decrease.
Plus / Minus Buttons (- and +)
Under the Alpha Wheel. Press to increase or decrease the value of the currently selected
parameter by the smallest possible amount. Don’t confuse this with the
+/-
button on the
alphanumeric buttonpad.
Alphanumeric Buttonpad
For Numeric Characters
Enter the value numerically instead of using the Alpha Wheel or
Plus
/
Minus
buttons. Press
Enter
when finished. Press
Cancel
to restore a parameter to its previous value. Pressing
Clear
is
equivalent to pressing
0
without pressing
Enter
.
For Alphabetic Characters
When naming objects, you can use the alphanumeric pad to enter letters instead of numbers. If
you’re renaming a program, for example, just position the cursor under the character you want
to change, then press the corresponding numeric button, as labeled. Press the button as many
times as necessary to enter the desired character. Pressing
Clear
will enter a space before the
selected character. The
0
button will enter the numerals 0–9 when pressed repeatedly.
Here’s an example. To enter the letter
C
in a blank space, press
1
three times. You can press the
+/-
button before or after entering the letter.
The
Cancel
button is equivalent to the
>>>
soft button, and
Enter
is the same as
OK
. The
Clear
button replaces the currently selected character with a space. The +/– button toggles between
uppercase and lowercase letters.
When you press the +/– button on the alphanumeric pad, the currently selected character (the
one with the cursor under it) will switch from upper case to lower case, and vice versa. The +/–
button is a toggle; that is, if you switch from lower to upper case, all further entries will be in
upper case until you press the +/– button again.
To Next Page
Loading...
