Triple Modular Processing
Editing Triples
12-11
In order to function as designed, DSP blocks that use NOISE+ must be followed immediately by
one of the DSP functions listed below. Otherwise, you won’t be able to attenuate the level of the
added noise. If you use NOISE+ in the last DSP block of a Layer-2 algorithm, the first DSP block
of Layer 3’s algorithm must be one of these functions.
Exploring the Possibilities
You may never exhaust the possible combinations of DSP functions available with triple-
modular processing, but keep experimenting. We’ve found that using simple waveforms when
trying different DSP functions makes it easier to hear the effects of each function. Try using
SINE, SQR, and SAW in various DSP blocks. These block all incoming audio signals and
generate a simple waveform as output (as opposed to SINE+, SQR+, and SAW+, which add
waveforms to the existing signal).
NONE +AMP
AMP +GAIN
PANNER XFADE
BAL AMP
To Next Page
Loading...
