EasyManua.ls Logo

Kurzweil K2661 - HF Stimulate 1; High-Frequency Stimulator; One Channel of High-Frequency Stimulation

Kurzweil K2661
500 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10-244
KDFX Reference
KDFX Algorithm Specications
972 HF Stimulate 1
High-frequency stimulator
PAUs: 1
The high-frequency stimulator algorithm is closely based on the V.A.S.T. High Frequency Stimulator DSP
function, and the manual description is repeated here (edited for KDFX specics).
The overall effect of a high-frequency stimulator is to boost the high frequency partials of the signal, and
depending on the settings of the parameters, it can add high-frequency partials to the signal as well. It’s
useful for building sounds that cut through the mix, and have a bright crisp nature.
There’s more to the high-frequency stimulator than meets the eye. It works like this: the signal is run
through a highpass lter, then through a distortion function, then through a second highpass lter. Finally.
it’s mixed with the original signal after passing through the nal Stim Gain level control of the algorithm.
The HF Stimulate 1 algorithm is a close copy of the V.A.S.T. DSP function, giving control of the rst
highpass lter frequency, the distortion drive and the amplitude of the result (Stim Gain). As a bonus, the
distortion curve can also be adjusted.
Figure 127 One channel of high-frequency stimulation
Parameters:
Page 1
Stim Gain The gain of the high frequency stimulated signal applied prior to being added to the
original input signal.
Out Gain The overall gain or amplitude at the output of the effect.
Dist Drive The amount to boost (or cut) the signal level to drive the distortion. Higher values will
increase the distortion of high frequency signal components.
Dist Curve The curvature of the distortion. 0% is no curvature (no distortion at all). At 100%, the
curve bends over smoothly and becomes perfectly at right before it goes into digital
clipping.
Highpass A rst order highpass lter that removes low frequencies prior to being distorted.
Stim Gain Off, -79.0 to 24.0 dB Out Gain Off, -79.0 to 24.0 dB
Dist Drive -79.0 to 48.0 dB Highpass 8 to 25088 Hz
Dist Curve 0 to 127%
L Input L Output
Distortion
HighPass A
HighPass B
Stim
Gain
Out Gain

Table of Contents

Other manuals for Kurzweil K2661

Related product manuals