Kurzweil K2661 - Pitcher+Miniverb; Combination Algorithm of Pitcher Followed by Miniverb; Signal Flow of Pitcher+Miniverb

10-134
KDFX Reference
KDFX Algorithm Specifications
745 Pitcher+MiniVerb
Combination algorithm of Pitcher followed by MiniVerb
PAUs: 2
Pitcher+MiniVerbis Pitcher followed by MiniVerb. Pitcher applies a filter to the signal, the filter having a
regular series of peaks in its frequency response which generally imposes a pitch on the input signal. The
MiniVerb reverb is then applied to the “pitched” signal. See the relevant sections for complete details on
these algorithm components.
There are several parameters for controlling the routing and mixing of signals. As might be expected,
Wet/Dry sets the level of the wet (Pitcher+MiniVerb) signal relative to the main dry input signal. The
Mix Pitcher and Mix Reverb parameters set the amounts of the outputs of both of the component effects to
send to the main algorithm outputs. The Pch/Dry>Rv parameter sets the amount of pitcher signal to feed
to the reverb relative to dry input signal.
Figure 59 Signal flow of Pitcher+MiniVerb
Parameters:
Page 1
Page 2
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0 dB
Mix Pitcher 0 to 100%
Mix Reverb 0 to 100%
Pt Pitch C -1 to G 9
Pt Offst -12.0 to 12.0 ST
Pt Odd Wts -100 to 100%
Pt Pair Wts -100 to 100%
Pt 1/4 Wts -100 to 100%
Pt 1/2 Wts -100 to 100%
Mix Pitcher
Pitcher MiniVerb
Pch/Dry > Rv
Mix
Reverb
Wet Out Gain
Dry