C-2
Standard K2661 ROM Objects
Special Purpose Setups
Special Purpose Setups
There are three special setups at the end of the Zeros bank:
97 Control Setup Lets you define controller assignments in Program mode. You can
customize and select the control setup on the MIDI-mode TRANSMIT
page.
98 Clear Setup A template for creating your own control assignments from a clear
palette.
99 Default Setup Lets you create your own setups from our common settings (shown
below). The NewZn parameter uses this setup as its template for creating
new zones.
Slider A: Data Continuous Controller Pedal 1: Foot (MIDI 4)
Slider B: MIDI 22 Continuous Controller Pedal 2: Breath (MIDI 2)
Slider C: MIDI 23 Small Ribbon Position: Aux Bend 2
Slider D: MIDI 24 Small Ribbon Pressure: Mono Pressure
Slider E: MIDI 25 Large Ribbon: Aux Bend 1
Slider F: MIDI 26 Pitch Wheel: BendUp
Slider G: MIDI 27 Mod Wheel: MWhl
Slider H: MIDI 28 Panel Switch 1: Arpeggiator On/Off
Footswitch 1: Sustain Panel Switch 2: MIDI 29
Footswitch 2: Sostenuto Mono Pressure: MPress
Footswitch 3: Soft Pedal
Footswitch 4: TapTempo
To Next Page
Loading...
