1-4
Front Panel
Special Button Functions
MIDI Faders button
When you press the MIDI Faders button, the K2661’s sliders take on the functions assigned on
the current MIDI Faders page. From the MIDI Faders display you can define four different pages
that define how the K2661’s physical sliders will work. In the display shown below, for example,
the eight sliders are each defined to send MIDI 6 (Data) on Channels 9 through 16. Press one of
the Page soft buttons to use (or create) a different page of MIDI fader assignments. Use the Send
soft button to transmit values without moving the faders.
The MIDI Faders pages is saved as part of the Master table object.
Assignable Controllers (Buttons 1–8 and Sliders A–H)
The function of these controllers will depend on how they’ve been defined within a setup.
Buttons 1–8 control either zone muting or KB3 features, depending on the value of the value of
the Mutes parameter on the COMMON page in the Setup Editor. The SLIDER and SLID/2 pages
configure the functions of Sliders A–H.
PSw1, PSw2 (Buttons 9 and 10)
The function of these controllers depends on how they’ve been defined on the SWITCH page in
the Setup Editor.
Record, Play/Pause, Stop
These buttons duplicate the functions of the corresponding soft buttons in Song mode, allowing
you to conveniently record, play, pause, and stop the current song.
Special Button Functions
The Mode buttons and the Chan/Bank Down button have additional functions, depending on
the mode or editor you’re in. When you’re in the Program or Setup Editor, they function
according to the blue labeling under each button. They also work as track mutes on the MIX
page of Song mode.
MIDI|Faders:Page2|||||||||||||||||||||||
Chan|:|9|||10||11||12|||13|||14||15||16|
Ctl||:|6|||6|||6|||6||||6||||6|||6|||6||
Value:|0|||0|||0|||0||||0||||0|||0|||0||
||||||||||||||||||||||||||||||||||||||||
||||||\]||}~||\]||}~||||\]||}~||\]||}~||
|||||||_|||_|||_|||_|||||_|||_|||_|||_||
Page1||Page2||Page3||Page4|||Send|||Done
To Next Page
Loading...
