10-34
KDFX Reference
KDFX Algorithm Specifications
signal from entering the delay. You may have to practice using the Hold parameter. Each time your sound
goes through the delay, it is reduced by the feedback amount. If feedback is fairly low and you turn on
Hold at the wrong moment, you can get a disconcerting jump in level at some point in the loop. The Hold
parameter has no effect on the Wet/Dry or HF Damping parameters, which continue to work as usual, so
if there is some HF Damping, the delay will eventually die out.
See also the versions of these algorithms which specify delay lengths in terms of tempo and beats.
Parameters for Algorithm 133 8-Tap Delay
Page 1
Page 2
Page 3
Page 4
Wet/Dry The relative amount of input signal and delay signal that is to appear in the final effect
output mix. When set to 0%, the output is taken only from the input (dry). When set to
100%, the output is all wet.
Out Gain The overall gain or amplitude at the output of the effect.
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0 dB
Fdbk Level 0 to 100%
Xcouple 0 to 100% Dry Bal -100 to 100%
HF Damping 16 Hz to 25088 Hz Hold On or Off
Loop Crs 0 to 5100 ms DelayScale 0.00x to 10.00x
Loop Fine -20 to 20 ms
Tap1 Crs 0 to 5100 ms Tap3 Crs 0 to 5100 ms
Tap1 Fine -20 to 20 ms Tap3 Fine -20 to 20 ms
Tap2 Crs 0 to 5100 ms Tap4 Crs 0 to 5100 ms
Tap2 Fine -20 to 20 ms Tap4 Fine -20 to 20 ms
Tap5 Crs 0 to 5100 ms Tap7 Crs 0 to 5100 ms
Tap5 Fine -20 to 20 ms Tap7 Fine -20 to 20 ms
Tap6 Crs 0 to 5100 ms Tap8 Crs 0 to 5100 ms
Tap6 Fine -20 to 20 ms Tap8 Fine -20 to 20 ms
Tap1 Level 0 to 100 % Tap5 Level 0 to 100 %
Tap2 Level 0 to 100 % Tap6 Level 0 to 100 %
Tap3 Level 0 to 100 % Tap7 Level 0 to 100 %
Tap4 Level 0 to 100 % Tap8 Level 0 to 100 %
Tap1/-5Bal -100 to 100 % Tap3/-7Bal -100 to 100 %
Tap2/-6Bal -100 to 100 % Tap4/-8Bal -100 to 100 %
To Next Page
Loading...
