KDFX Reference
KDFX Algorithm Specifications
10-127
VC+Tube+Rotor 4 faithfully models the response and smooth distortion caused by overloading a vacuum
tube circuit.
Parameters (VC+Tube+Rotor 4):
Page 1 (VC+Tube+Rotor 4)
Page 2
Page 3
Page 4
In/Out When set to In, the algorithm is active; when set to Out the algorithm is bypassed.
In/Out Gain The overall gain or amplitude at the input or output of the effect. For distortion, it is often
necessary to turn the output gain down as the distortion drive is turned up.
VibChInOut When set to In the vibrato/chorus is active; when set to Out the vibrato/chorus is
bypassed.
Vib/Chor This control sets the Hammond B3 vibrato/chorus. There are six settings for this effect:
three vibratos V1, V2, and V3, and three choruses C1, C2, and C3.
In/Out In or Out In Gain Off, -79.0 to 24.0 dB
VibChInOut In or Out Out Gain Off, -79.0 to 24.0 dB
Vib/Chor V1 Tube Drive Off, -79.0 to 60.0 dB
Roto InOut In or Out Cabinet LP 8 to 25088 Hz
Xover 8 to 25088 Hz
Lo Gain Off, -79.0 to 24.0 dB Hi Gain Off, -79.0 to 24.0 dB
Lo Rate -10 to 10 Hz Hi Rate -10 to 10 Hz
Lo Size 0 to 250 mm Hi Size 0 to 250 mm
Lo Trem 0 to 100% Hi Trem 0 to 100%
Hi Beam W 45.0 to 360.0 deg
LoMicA Pos -180.0 to 180.0 deg LoMicB Pos -180.0 to 180.0 deg
LoMicA Lvl 0 to 100% LoMicB Lvl 0 to 100%
LoMicA Pan -100 to 100% LoMicB Pan -100 to 100%
HiMicA Pos -180.0 to 180.0 deg HiMicB Pos -180.0 to 180.0 deg
HiMicA Lvl 0 to 100% HiMicB Lvl 0 to 100%
HiMicA Pan -100 to 100% HiMicB Pan -100 to 100%
LoResonate 0 to 100% HiResonate 0 to 100%
Lo Res Dly 10 to 2550 samp Hi Res Dly 10 to 2550 samp
LoResXcurs 0 to 510 samp HiResXcurs 0 to 510 samp
ResH/LPhase 0.0 to 360.0 deg
To Next Page
Loading...
