Control Sources
MIDI Control Source List
4-5
MIDI Control Source List
With a few exceptions, the MIDI control sources correspond to the standard MIDI controller
numbers used by every MIDI device.
128 OFF
This value eliminates the effect of any control source parameter to which it’s
assigned.
0, 33 Mono Pressure (MPress)
Many of the K2661’s factory programs are assigned to modify parameters such as
pitch, filter cutoff frequency, and depth control when MPress messages are received.
The mono pressure (Press) control assignment parameters in MIDI and Setup
modes are set by default to transmit MPress messages when mono pressure
messages are received from a controller.
1 MIDI 01 (MWheel)
Many factory programs are assigned to respond to MWheel messages. The MWhl
parameter in the Setup Editor is set by default to transmit MWheel.
2 MIDI 02 (Breath)
3 MIDI 03
4 MIDI 04 (Foot)
This is the standard MIDI Controller number for continuous control foot pedals. It’s
the default value for the CPedal control assignment parameter, so a control pedal on
your MIDI controller which sends MIDI controller 04 messages will send MIDI
controller 04 messages to the K2661 by default.
5 MIDI 05 (PortTim)
This is the standard MIDI controller number for portamento time control. The
K2661 always responds to this control message. For any program that has
portamento turned on (on the COMMON page in the Program Editor), MIDI
Portamento Time messages received via MIDI will affect the rate of the program’s
portamento.
6 MIDI 06 (Data)
MIDI 06 is the standard MIDI controller number for data entry. The Slider A
parameter on the SLIDER page in the Setup Editor is set by default to transmit this
message, and can be used to select programs and edit parameters on MIDI slaves if
your controller can send it.
7 MIDI 07 (Volume)
This is the standard MIDI controller number for volume. The Volume parameter on
the CHANNELS page in MIDI mode will respond to MIDI controller 07 unless the
VolLock parameter is turned on.
To Next Page
Loading...
