10-142
KDFX Reference
KDFX Algorithm Specifications
Page 3
Page 4
Page 5
Out Gain The overall gain or amplitude at the output of the entire algorithm.
GateIn/Out When set to In the gate is active; when set to Out the gate is bypassed.
GateSCInp Select the input source channel for gate side-chain processing—left, right or both. For both
(L+R)/2 the averaged magnitude is used.
CompIn/Out When set to In the compressor is active; when set to Out the compressor is bypassed.
CompSCInp Select the input source channel for compressor side-chain processing—Left, Right or
Both. For both (L+R)/2 the averaged magnitude is used.
FdbkComprs A switch to set whether the compressor side-chain is configured for feed-forward (Out) or
feedback (In).
Gate Thres The signal level in dB required to open the gate (or close the gate if Gate Duck is on).
Gate Duck When set to Off, the gate opens when the signal rises above threshold and closes when
the gate time expires. When set to On, the gate closes when the signal rises above
threshold and opens when the gate time expires.
Gate Time The time in seconds that the gate will stay fully on after the signal envelope rises above
threshold. The gate timer is started or restarted whenever the signal envelope rises above
threshold. If Retrigger is On, the gate timer is continually reset while the side chain signal
is above the threshold.
Comp Atk 0.0 to 228.0 ms Comp Ratio 1.0:1 to 100:1, Inf:1
Comp Rel 0 to 3000 ms Comp Thres -79.0 to 0.0dB
CompSmooth 0.0 to 228.0 ms CompMakeUp Off, -79.0 to 24.0 dB
CompSigDly 0.0 to 25.0ms
CmpSCBassG -79.0 to 24.0 dB CmpSCTrebG -79.0 to 24.0 dB
CmpSCBassF 8 to 25088 Hz CmpSCTrebF 8 to 25088 Hz
CmpSCMidG -79.0 to 24.0 dB Comp SC EQ In or Out
CmpSCMidF 8 to 25088 Hz
CmpSCMidW 0.010 to 5.000 oct
Reverb W/D 0 to 100 %wet
Rv Type Hall1, etc.
Rv Time 0.5 to 30.0 s, Inf
Rv DiffScl 0.00 to 2.00x Rv Density 0.00 to 4.00x
Rv SizeScl 0.00 to 4.00x Rv HF Damp 8 to 25088 Hz
Rv PreDlyL 0 to 620 ms Rv PreDlyR 0 to 620 ms
To Next Page
Loading...
