10-146
KDFX Reference
KDFX Algorithm Specifications
Basic Flat response from 100 Hz to 4 khz with 24dB/oct rolloffs on each end
Lead 12 Open back hard American type with one 12” driver
2x12 Closed back classic American type with two 12” drivers
Open 12 Open back classic American type with one 12” driver
Open 10 Open back classic American type with one 10” driver
4x12 Closed back British type with four 12” drivers
Hot 2x12 Closed back hot rod type with two 12” drivers
Hot 12 Open back hot rod type with one 12” driver
Parameters (Gate+TubeAmp):
Page 1
Page 2
Page 3
In/Out When set to In the effect is active; when set to Out the effect is bypassed.
Out Gain The overall gain or amplitude at the output of the entire algorithm.
GateIn/Out When set to In the gate is active; when set to Out the gate is bypassed.
GateSCInp Select the input source channel for gate side-chain processing—left, right or both. For both
(L+R)/2 the averaged magnitude is used.
Gate Chan Select which input channel will receive gate processing—left, right or mix. This selects the
mono input for the algorithm.
Gate Thres The signal level in dB required to open the gate (or close the gate if Ducking is On).
In/Out In or Out Out Gain Off, -79.0 to 24.0 dB
GateIn/Out In or Out
GateSCInp L, R, (L+R)/2
Gate Chan L, R, (L+R)/2
Gate Thres -79.0 to 0.0 dB Gate Time 25 to 3000 ms
Gate Duck On or Off Gate Atk 0.0 to 228.0 ms
Gate Rel 0 to 3000 ms
GateSigDly 0.0 to 25.0 ms
|||||||||||||||||||||||||||||| Reduction
-dB 60 40 ❃ 16 ❃ 8 4 0
Bass Tone 0.0 to 10.0 Tube Drive Off, -79.0 to 60.0 dB
Mid Tone 0.0 to 10.0 Warmth 8 to 25088 Hz
Treb Tone 0.0 to 10.0 Cab Preset Open 12, ...
To Next Page
Loading...
