10-188
KDFX Reference
KDFX Algorithm Specifications
LFO Rate The frequency of the LFOs that drive the pitch shifter. The pitch shifter produces a certain
amount of tremolo that will oscillate based on this rate. However reducing the rate will
increase the delay lengths needed by the pitch shifter.
Shift Crs A coarse adjust to the pitch shift amount from -24 to +24 semitones. The algorithm
performs best when the amount of pitch shift is small.
Shift Fine A fine adjust to the pitch shift amount from -100 to +100 cents (hundredths of a semitone).
Lowpass A lowpass filter in the algorithm feedback loop. Use the lowpass to tame some of the
higher frequency artifacts. This is especially important when using feedback.
Highpass A highpass filter in the algorithm feedback loop. Use the highpass to tame the lower
frequencies when using feedback.
To Next Page
Loading...
