Kurzweil PC3K8 - Page 133

Setup Mode
The Control Setup
7-3
Control Setup–Setup
Editor Page, Zone 1
Parameters Affecting
Program Mode
Parameters Not Affecting
Program Mode
CH/PROG Arpeggiator, Destination,
BankMode
LocalPrg, Channel, MIDIBank,
MIDIProg, Status, EntryProgChg
KEY/VEL All
PAN/VOL ExitVolume, ExitPan EntryVolume, EntryPan
BEND AuxBend1Up,
AuxBend1Dwn,
AuxBend2Rng
BendRangeUp(ST),
BendRangeUp(ct),
BendRangeDown(ST),
BendRangeDown(ct),
COMMON Tempo, ArpSync Clock source, ArpGlobal, Aux FX
channel, Mutes, KB3 channel
ARPEGGIATOR All
RIBCFG All
Continuous Controller
assignment pages
(SLIDER, SLID/2,
CPEDAL, RIBBON,
WHEEL, PRESS)
Dest, Scale, Add, Curv Ent, Exit
Switch Controller
assignment pages (FT
SW1, FT SW2, FT SW3,
ARP SW, SWITCH,
SWPRG1, SWPRG2,
SWPRG3, SWPRG4,
SWPRG5, SWPRG6,
SWPRG7, SWPRG8)
Type, OnControl, OnValue,
OffControl, OffValue,
EntryState
ExitState
RIFF1, RIFF2 All
FX, AUXFX1, AUXFX2,
MASTFX
All
Table 7-1 Control Setup Parameters Affecting Program Mode