7-22
Setup Mode
Controllers
Switch Controllers
SeeSwitchControllerParameters on page 7‐31forinformationoneachparameter.
The Controller Destination List
ThetablebelowcontainstheavailablevaluesfortheDestinationparameterforeachcontroller,
inscrollingorder.NotethatthePC3KhasdestinationswithControllerNumbersgreater than
127—thereare128MIDIControllers,asdictatedbytheMIDIspec.Anydatasenttodestinations
withaControllernumberoutsideofthe
MIDIrange(i.e.,morethan127)aresentasaPC3K‐
specificprotocol,andarethusnotsentasMIDIdata,andnotsentthroughMIDIOut.
Physical Controller
Setup Editor 
Page
Parameter:Values
Footswitches 1, 2, and 3
FT SW1,
FT SW2,
FT SW3
SwType: Toggle, Momentary, Note Toggle, 
Note Momentary
Destination: Control Destination List
On Value: None, 0 to 127
Off Value: None, 0 to 127
Entry Value: None, Off, On
Exit Value: None, Off, On
Arp and SW switches
ARP SW, 
SWITCH
(same as Footswitches)
Programmable switches 1 to 8
SWPRG1, 
SWPRG2, 
SWPRG3, 
SWPRG4, 
SWPRG5, 
SWPRG6, 
SWPRG7, 
SWPRG8
(same as Footswitches)
Table 7-4 Switch Controllers
Controller 
Number
Corresponding 
Destination 
Name
Description
0 OFF/Bank By default, when you enter 0 or Clear for the Destination 
parameter, the destination will be assigned to OFF. To select 
Bank as the destination, use the Alpha Wheel or -/+ buttons.
1 MWheel Default assignment for Mod Wheel
2 Breath  Default assignment for Breath Controller
3MIDI 03
4 Foot Default assignment for CC Pedal 2
5 PortTim Monophonic PC3K programs respond to this Controller if 
portamento is turned on
Table 7-5 Controller Destination List