Kurzweil PC3K8 - Appendix C Changing PC3 K Voltage; Removing the Fuse Holder

C--1
Appendix C
Changing PC3K Voltage
Inmostcases,youwillnotneedtochangethevoltageonyourPC3K.However,sincedifferent
countriesusedifferentstandardvoltagesettings,theremaybetimeswhenyouneedtomakethe
change.
ThePC3K’sfuseholder(wherethepowercableplugsin)iswhereyouchangethevoltage.The
marksonthefuseholderare115and230.115shouldbeusedforvoltagesfrom100to125.230
shouldbeusedfor200to240.Generally,NorthAmericauses115,andEuropeandAsia/
Australiause230,butthereareexceptionstothisgeneralrule.
ThePC3Kusestwo250
mAfastblowfusesfor230Vortwo500mAfastblowfusesfor115V.
Thesecanbeeither1.25ʺX0.25ʺsizeor5mmX20mmsizefuses.Extrafusesarenotprovided,
soyouwillneedtoacquirethecorrectfusebeforeyouchangethevoltage.
Removing the fuse holder
Removethepowercord.
Pryopenthefuseholdercover.Useathintoolinsertedintotheholewheretheredvoltage
indicatorshowsthrough.