Kurzweil PC3K8 - Override; Chain; Output; Mod Override

9-6
Effects
The AUXFX1 and AUXFX2 Pages
IfOverrideissettoNo,thetoplineofthepagedisplaystheAux1Chainthatisloadedforthe
currentprogram,aswellasthecurrentchannel.Inthecaseofthescreenshotbelow,theAux1
Chainofthecurrentprogramis906MediumHall2,and
thecurrentchannelis6.
Override
ThisparameterswitchesonorofftheAuxoverride.SetOverridetoYestoselectanoverride
AuxChainonthispage.SetOverridetoNotoallowthecurrentprogram(orzoneortrack).
Chain
WhenOverrideissettoYes,youcanselectanoverrideAuxChainforthepage’scorresponding
Auxbus.ThisparameterisnotvisiblewhenOverrideissettoNo.
Output
Thisparameterspecifiesthephysicalaudiooutputpairforthepage’scorrespondingAux
Chain’soutput.ThesettingsPri.andSec.refer,respectively,totheprimary(labeled“MAIN”on
thebackpanel)andsecondary(labeled“AUX”onthebackpanel)physicalaudiooutputsofthe
PC3K.SettingOutputtoautousesthe
outputpairspecifiedinthecurrentprogram(orthe
programonthespecifiedAuxEffectschannel).
Mod Override
ThisparametercanbeusedtooverridetheModControlsourceofthecurrentprogram(orthe
programonthespecifiedAuxEffectschannel).AsettingofNoneyieldsnooverrideinMod
Controlsource,andusestheModControlsourcespecifiedinthecurrentprogram.
Send Levels and Pre/Post Ins.
Therearetwoparametersforeachofthe16MIDIchannels:SendLevel(toprow)andPre‐/Post‐
Insert(bottomrow).ThesettingfortheparameterSendLeveldeterminesifthecurrentprogram’s
AuxSendLevelisoverridden,andifso,bywhatvalue.ThesettingfortheparameterPre‐
/Post‐
Insertdeterminesifthecurrentprogram’sAuxroutingisoverridden,andifso,bywhatrouting.
PremeansthattheAuxSendtakesplacebeforeanyInsertEffectisapplied,whereasasettingof
PstmeansthattheAuxSendtakesplacepost‐InsertEffect.(Ofcourse,iftheprogram
onthe
channelhasnoInsertEffectsloaded,thenthisparameterwillmakenodifference.)ForbothSend
LevelandPre‐/Post‐Insert,avalueof[p]means“nooverride”(i.e.,usethevaluesspecifiedinthe
program).