Kurzweil PC3K8 - Remap; Song Editor: the EVENT Page; Initial Program, Volume, Pan; Event Type and Value

Song Mode and the Song Editor
Song Editor: The EVENT Page
12-31
Remap
UsetheRemapfunctiontoapplythevaluesofanyonetypeofcontrollerdata,alreadyrecorded
onatrack,toanothercontrollertype.Theeffecttherealtimechangesofthe“Old”controllerhad
willbereplacedbytheeffectthe“New”controllerhasbyusingtheexactsamecontroller
values.
Old:ControlSourceList(0to120)
The“Old”ControllerissettotheControllertypethatyouwishtoremap.ThisControllerdata
mustalreadyexistonthecurrenttrackinordertoapplyittothe“New”Controllertype.
New:ControlSourceList(0to120)
The“New”
parameterissettotheControllercodeyouwishtohaveusetheexistingvalues,
onceusedbythe“Old”Controller,toproduceadifferenteffect.
Song Editor: The EVENT Page
EverytypeofrecordedMIDIeventisvisiblefromthispage.Youcanviewandchangethese 
eventsifnecessary.Eachtrackdisplaysitsinitialprogram,volume,andpanatthetopofits
eventlist.Youcanalsoaccessthetempotrack(instructionsbelow.)
Thetoplineofthepage
displaysthecurrentsongpositioninthecenter,andthecurrently
selectedtrackandcorrespondingchannelontheright.UsetheChan/Layerbuttonstoselectan
activetracktoviewandedittheMIDIeventsrecordedonit.
Location
Bar:Beat:Tick
Event Type and Value
Initial
Program,
Volume,
Pan