Kval Commander - Control Panel Operations; Jamb Clamp Pedal; Door Clamp; Door Width Adjustable

This page contains Kval, Inc. proprietary information and is not to be duplicated or disclosed to unauthorized persons.
27
CONTROL PANEL OPERATIONS
Jamb Clamp Pedal:
The jamb clamp pedal is used to clamp the jamb into position for routing jamb pockets.
Adjust the clamp pressure by turning the regulator knob located beneath the main
control panel. Clamp pressure has been factory set at between 45 & 55 PSI. KVAL
recommends that clamp pressure not be adjusted higher than 55 PSI, due to jamb flex,
resulting in jamb pockets being cut too deep. The bar running from the door clamp
pedal to the jamb clamp pedal, causes the jamb to unclamp when the door is released
WARNING:
Make sure that Hands are clear of the Clamps at all TIME!
Door Clamp:
The door clamp pedal secures the door into position for machining.
Warning: Keep yourself, and other clear of the commander while clamping –
especially the Front face clamp and jamb indexing fixtures.
Door Width Adjustable:
The door width adjustment drum switch is located on the left end of the commander.
Unclamp the machine using the Door Clamp Pedal. Turn the door width adjustment
drum switch while watching the width indicator move up or down the measurement
scale on the left end of the Commander’s frame. Release the door width adjustment
switch when the width indicator reaches the measurement of the width of your door
with in +/- ¼”
Control Transformer:
The control transformer button turns on the power within the electrical box.
Start Machine:
The start machine button turns on the Commander’s motors, and computer. The start
machine button does not start the commander’s cycle of operation.
Back Section/ Both / Front Section:
This switch allows the operator the choice of machining hinge pockets, or lock preps
independently. The BOTH command combines these functions in one machining pass.
Lock Bore Off / Reg. / Deep:
The REG. command machines bypass doors. The DEEP command machines normal
bores and different diameter cylinder and dead bolt holes without having to remove the
drill bit. Deep is used to access the second larger diameter cutter shaft.
Bolt Drill Off/ On:
The Bolt Drill selector switch controls the operation of the bolt drill. Select On for bolt
drill machining.