This page contains Kval, Inc. proprietary information and is not to be duplicated or disclosed to unauthorized persons.
46
SWITCHING TO BEVEL PLATES:
There are handles attached to the two position blocks that restrict the pivot in position of the face
plate router. The blocks have half round notches cut at different depths that mate with the upper
shaft of the face plate router carriage. To adjust for bevel plates, loosen the ratchet handle on the
front of the lock section, then pull up all the way on the 4 pronged handle before re tightening the
ratchet handle. Repeat this process on the other end of the lock section.
If you have any problems with inconsistent plate depth be sure that both bevel locks are mating
correctly with the upper router carriage shaft. Stop nuts attached to the upper 4 prong knobs make
adjustments straight forward.
SIDE DRILL (LATCH HOLE):
The side drill bit has a 4" long fluted section. For 5" back sets and over bored dead bolts you'll
need to put in a 6" bit. Be certain the machine is locked out electrically and disconnect air
service. Finally, wait until the bit has come to a full stop before getting out the collet wrenches.
Be Certain That The Face Plate Router Depth Is Correct And That The Router Cord Is Fastened
To The Router; Otherwise The Long Bit Will Eat The Router.
To Next Page
Loading...