114
CAUTION:
Battery
This model adopts the battery which needs no
refilling of distilled water.
When cleaning the terminal terminals, remove the
screws attaching the battery cover under seat and
then open the battery cover.
When battery terminals are corroded, take out the
battery for cleaning.
After cleaning, apply a thin coat of grease or
Vaseline to battery terminals and then install the
battery.
Never open the closed-type battery electrolyte
cap.
If the motorcycle will not be used for a long time,
the battery will discharge electricity by itself.
Remove the battery and put it in a cool place
after it is fully charged to prevent electricity
leakage
If the motorcycle will not be used for a long time,
remove the negative (-) terminal.
Do not smoke or allow flames or sparks near
the battery while removing and installing it.
Turn off the ignition switch before removal or
installation. The negative (-) terminal shall be
removed first and the positive (+) terminal shall
be installed first.
Tighten the loose terminal screws securely.
1. Battery
To Next Page
Loading...
