EasyManua.ls Logo

KYMCO MX'er 150 - 2-Stroke Motor Oil (Only MXer 50)

KYMCO MX'er 150
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
H. Fill the engine with oil and install the dipstick. 2-stroke motor oil (only MX'er 50)
When the main switch is at " " position, it is
Normalifthe
motor oil indicator light comes on for several
seconds and then goes out. If the light does
not go out, it means that the motor oil is
insufficient. Please refill with the specified
Motor oil.
2. Motor oil level inspection and refilling
1. Motor oil indicator light
Recommended oil: see page 125
Oil quantity:
Periodic oil change
0.9L(0.79lmpqt,0.95USqt)
Total amount:
1.0L(0.85lmpqt,1.05USqt)
Be sure no foreign material enters the
crankcase.
If oil leakage is found, stop the engine
immediately and check for the cause.
I. Warm up the engine for several minutes at idle
Speed. Check for oil leakage while warming
up.
90
CAUTION:
CAUTION:
1. Motor oil tank 2. Cap

Table of Contents

Related product manuals