D. Remove the dipstick and drain plug to drain
the oil.
When removing the drain plug, the
compression spring, oil strainer and O-ring
will fall out. Take care not to lose these
parts.
Before reinstalling the drain plug, be sure
to install the O-ring, compression spring
and oil strainer.
E. Clean the oil strainer with solvent.
F. Inspect the O-ring and replace if damaged.
G. Reinstall the O-ring, oil strainer, compression
spring and drain plug. Tighten the drain plug
to specification.
Tightening torque:
Drain plug (engine):
32 Nm (3.2 m-kg, 23 ft-lb)
Oil straine:
20 Nm (2.0 m-kg, 14 ft-lb)
89
CAUTION:
1. Drain plug 2. Oil strainer
CAUTION:
To Next Page
Loading...
