Engine oil (only MX'er 150/125)
1.Engine oil level measurement
A. Place the machine on a level place.
B. Warm up the engine for several minutes
and stop it.
C. Remove the dipstick and wipe it off with a
clean rag. Insert the dipstick in the filler
hole without screwing it in.
D. Remove the dipstick and inspect the oil
level.
E. The oil level should be between the
maximum and minimum marks. If the level
is low, add oil to raise it to the proper level.
Wait a few minutes until the oil level settles
before checking.
Be sure no foreign material enters the
crankcase.
2. Engine oil replacement and oil filter cleaning
A. Place the machine on a level place.
B. Warm up the engine for several minutes
and stop it.
C. Place a container under the engine.
88
NOTE:
CAUTION:
1. Dipstick
3. Minimum level mark
2. Maximum level mark
To Next Page
Loading...
