5. Install the headlight unit assembly.
Adjust the headlight beam if necessary.
118
Headlight beam adjustment
It is advisable to have a KYMCO dealer make
this adjustment.
Vertical adjustment:
To raise the beam, loosen the adjusting screw
and pull the headlight assembly toward you.
To lower the beam, push it away from you. After
adjusting, be sure to tighten the screw.
CAUTION:
1. Adjusting screw
3. Put a new bulb into position and secure it in
place with the bulb holder.
4. Install the bulb holder cover.
Make sure the bulb holder cover is securely
fitted over the bulb holder and seated
against the reflector.
CAUTION:
To Next Page
Loading...
