9.DRIVE AND DRIVEN PULLEYS
9-15
MXU 300/250
Install the drive pulley and ratchet.
Install and tighten the nut.
Torque: 9.5 kgf-m (95 Nm, 68 lbf-ft)
When installing the drive pulley face,
compress it to let the drive belt move
downward to the lowest position so that the
drive pulley can be tightened.
Make sure the ratchet into the splines on the
crankshaft when the ratchet is installed.
Do not get oil or grease on the drive belt or
pulley faces.
＊
SplinesSplines
To Next Page
Loading...
