KYMCO MXU 300 - EXHAUST MUFFLER

2. FRAME COVERS/EXHAUST MUFFLER
2-11
MXU 300/250
EXHAUST MUFFLER
REMOVAL/INSTALLATION
Remove the exhaust pipe joint nuts.
Remove the muffler mounting bolt, nut and
exhaust muffler.
Inspect the gasket.
If the exhaust gas leaks, the gasket should
be replaced.
Installation is in the reverse order of
removal.
Torque:
Exhaust muffler lock bolt:
3.5 kgf-m (35 Nm, 25 lbf-ft)
Exhaust muffler lock nut:
3.5 kgf-m (35 Nm, 25 lbf-ft)
Joint Nuts
Gaske
t
Nu
t
Bol
t
Be sure to install a new exhaust gasket.
＊