KYMCO MXU 300 - Air Filter for Drive Belt

3. INSPECTION/ADJUSTMENT
3-6
MXU 300/250
CLEAN AIR FILTER ELEMENT
Wash the element gently, but throughly in
solvent.
Squeeze the excess solvent out of the
element and let dry.
Apply the engine oil.
Squeeze out the excess oil.
More frequent replacement is required when
riding in unusually dusty or rainy areas.
AIR CLEANER HOUSING DRAIN
Remove the drain tube (under air cleaner
case) by removing the clip.
Drain the deposits.
Reinstall the drain tube, securing it with the
clip.
AIR FILTER FOR DRIVE BELT
To clean the air filter:
Remove front center cover. (See page 2-7)
Remove air filter.
Tap the element lightly to remove most of
the dust and dirt.
Blow out the remaining dirt with
compressed air.
Installation is in the reverse order of
removal.
If necessary replace the air filter.
Use parts cleaning solvent only. Neve
r
use gasoline or low flash point solvents
which may lead to a fire or explosion.
＊
Do not twist or wring out the foa
m
element. This could damage the foam
material.
＊
The element should be wet but not
dri
pp
in
g
.
＊
Air Cleaner Housing
Drain Tube
Clip
Air Filte
r