15. REAR WHEEL/AXLE/SUSPENSION/
DRIVING MECHANISM
15-40
MXU 300/250
Drive the rear axle bearing out of the left
axle hosing.
Drive in the new bearings squarely until it is
fully seated.
Special tool:
Oil seal & bearing installer E014
Pack 3 g (0.1 oz) of grease into bearing
cavity.
REAR DRIVING MECHANISM
(MXU 300)
INSTALLATION
Apply grease to new O-ring and install it
into the groove in the swingarm.
Install the dust plate and tighten the three
bolts securely.
Clean the mating surfaces of the gear case
and swingarm.
Coat new O-rings with grease and install
them into the grooves in the gear case.
Bolts
O-ring Dust Plate
O-rings
To Next Page
Loading...
