KYMCO MXU 300 - Page 89

5. FUEL SYSTEM
5-8
MXU 300/250
Remove the spring from the throttle valve
Pry off the needle retainer and remove the jet
needle.
Check the throttle valve and jet needle for
wear or damage.
ASSEMBLY
Reverse the “DISASSEMBLY” procedures.
Install the throttle valve into the carburetor
body.
Throttle Valve
N
eedle Retaine
r
Spring
Jet Needle Clip
Align the groove in the throttle valve
with the throttle stop screw on the
carburetor body.
＊
Throttle Stop Screw
Groove