Operation Panel
4-90
Except for Europe
There are two sleep modes with different levels of sleep: Quick Recovery and Energy Saver.
Quick Recovery Mode: The recovery from the sleep mode is faster than when using Energy Saver mode.
Energy Saver Mode: This makes it possible to reduce energy consumption even further than with Quick Recovery mode.
With Energy Saver mode, you can set whether to enable the Energy Saver mode for each separate function.
1
In the Timer Setting menu, press or to select Sleep Level
Set..
2
Press [OK]. The Sleep Level Set. menu screen appears.
3
Press or to select Sleep Level.
4
Press [OK]. The Sleep Level screen appears.
5
Press or to select Quick Recovery or Energy Saver.
6
Press [OK]. The sleep level is set and the Sleep Level Set.
menu reappears.
When Energy Saver is set, next go on to set whether or not to use
Energy Saver mode for each function.
7
Press or to select Status.
8
Press [OK]. The Status menu screen appears.
Next set whether or not to use Energy Saver mode for each function.
Note
For information on the Quick Recovery mode and Energy Saver mode, refer to Energy Saver Function on
page 2-26.
When the optional Network Interface Kit (IB-50) or Wireless Network Interface Kit (IB-51) has been installed, the
Sleep Level Set. menu is not displayed and the machine will enter the Quick Recovery mode.
Item Default Value
Network (Network interface setting)
On
USB Cable (USB interface setting)
On
Card Reader (ID card reader setting)
Off
RAM Disk (RAM Disk Mode setting)
Off
Parallel Cable (Parallel interface setting)
Off
Note
Card Reader is only displayed when the ID card
reader function has been activated.
Parallel Cable is only displayed when the optional
Parallel Interface Kit (IB-32) has been installed.
To Next Page
Loading...
Need help?
General