To Next Page

To Previous Page

2-19

Preparation before Use

Select a category from the navigation bar on the left of the screen.

Changing Security Settings

This section explains how to change the security settings.

Launch your Web browser.

In the address or location bar, enter the machine's IP address or the

host name.

The factory default setting for the default user with administrator

privileges is shown below.

* Upper case and lower case letters are distinguished (case

sensitive).

From the Security Settings menu, select the setting you want to

configure.

Note

To fully access the features of the Command Center

RX pages, enter the User Name and Password and click

allows the user to access all pages, including Document Box

and Settings on the navigation menu. The factory default

setting for the default user with administrator privileges is

shown below.

* Upper case and lower case letters are distinguished (case

sensitive).

Note

Print the status page to check the machine's IP

address and the host name. For details, refer to Status Page

(Printing a printer's status page) on page 4-12.

Note

The configurable settings within Device Security and

Network Security can also be configured from the

machine's operation panel. For details, refer to Operation

Panel on page 4-1.

For details on settings related to certificates, refer to the

Command Center RX User Guide.

Kyocera ECOSYS FS-2100D User Manual

Other manuals for Kyocera ECOSYS FS-2100D