2
Preparation before Use
2-55
2 Place the originals. Put the side to be scanned (or the
first side of two-sided originals) face-up. Slide the
leading edge into the document processor as far as it will
go.
IMPORTANT: Confirm that the original width guides exactly
fit the originals. If there is a gap, readjust the original width
guides. The gap may cause the originals to jam.
Ensure that loaded originals do not exceed the level
indicator. Exceeding the maximum level may cause the
originals to jam (see the figure).
Originals with punched holes or perforated lines should
be placed in such a way that the holes or perforations will
be scanned last (not first).
To Next Page
Loading...
