Kyocera ECOSYS M6030cdn

5-8
Operation on the Machine > Program
Overwriting Program
You can change program. Use the procedure below to edit the program.
1
Configure the settings of the functions.
Set the function to change.
For the settings of functions, refer to the following:
.
2
Overwrite the program.
1 Press the one of the [ Program I ] to [ Program IV ] keys to change and hold it (2 seconds or
more).
2 [▲] [  ] key > [ Overwrite ] > [ OK ] key > [ Yes ]
Register the changed program.
Deleting Program
You can delete program.
1
Display the screen.
Press the one of the [ Program I ] to [ Program IV ] keys to delete and hold it (2 seconds or
more).
2
Delete the program.
[▲] [  ] key > [ Delete ] > [ OK ] key > [ Yes ]
Using Various Functions (page 6-1)
NOTE
In the case of the sending function and fax function, a destination is also registered in the
program.