5-23
Operation on the Machine > Sending
Recall
Recall is a function allowing you to send the last entered destination once again. When you want to send the image to
the same destination, select the [
Address Recall/Pause
] key, and you can call the destination you sent on the
destination list.
1
Select the [
Address Recall/Pause
] key.
The destination you sent is displayed on the destination list.
2
Press the [
Start
] key.
Sending starts.
Send to Me (E-mail)
When user login is enabled, the document is sent to the E-mail address of the logged in user.
1
In the basic screen for sending, select [ā²] [ā¼] key >
[Me(E-mail)] > [OK] key
When the last sending included FAX, computers and E-mail destinations, they are also
displayed. If necessary, add or delete the destination.
ā¢ When [
On
] is selected in "Check beforeSend", a destination confirmation screen is
displayed when you press the [
Start
] key.
Confirmation Screen of Destinations (page 5-22)
ā¢ Recall information is canceled in the following conditions.
- When you turn the power off
- When you send a next image (new recall information is registered)
- When you log out
An E-mail address must be set in user login for the user who logs in.
Adding a User (Local User List) (page 9-6)
To Next Page
Loading...
Need help?
General
