Using the Operation Panel 7-17
Copies (Number of copies)
Sets the number of copies printed of the specified file in USB memory.
IMPORTANT To use this feature, the RAM disk must be set to On.
1
While Copies in step 5 above is displayed, press and or and
to display the number of copies. (E.g.: 10)
2
Press [OK]. Paper Source and a question mark (?) appears.
Paper Source (Selecting the paper feed source)
Sets the paper used for printing the specified file in USB memory.
1
While Paper Source in step 2 above is displayed, press and
or and repeatedly until the paper source appears.
(For example : Cassette 2)
Note that menus shown in the list may vary depending on which
optional units installed in the printer.
2
Press [OK]. The message Processing appears and the printer
prints a file stored in a USB memory.
Remove Device (Removing the USB memory)
Specifies the setting for USB memory removal.
1
Press while USB Memory > is displayed.
2
Press or repeatedly until >Remove Device appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. Menu display ends and the USB memory device
can be removed.
Print File List (Printing a list of the files on a USB
memory)
This allows you to print a list of the files on a USB memory device.
1
Press while USB Memory > is displayed.
2
Press or repeatedly until >Print File List appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. The message Processing appears and the
printer prints a list of files stored in a USB memory.