4-4 Connecting and Printing
Changing Network Interface Parameters
This printer supports TCP/IP, TCP/IP (IPv6), IPP, SSL Server and the
IPSec protocols and Security Level.
The table below shows the items required for each of the settings.
Configure the printer's network parameters as appropriate for your PC
and your network environment.
For details of the procedure, refer to the Using the Operation Panel
section of the Advanced Operation Guide.
Note When Command Center RX is used, network
parameters and security settings can be conveniently changed
and checked from your PC. For more information, refer to
Command Center RX User Guide.
If the optional IB-50 or IB-51 is installed then NetWare and
AppleTalk settings are possible. For details, refer to Optional
Network section of the Advanced Operation Guide.
Menu Submenu Setting
Network TCP/IP On/Off
DHCP On/Off
Auto-IP On/Off
IP Address IP address
Subnet Mask IP address
Gateway IP address
Bonjour On/Off
TCP/IP (IPv6) On/Off
RA (Stateless) On/Off
DHCPv6 On/Off
Security I/F Block USB Host Block/Unblock
USB Device Block/Unblock
Option I/F Block/Unblock
USB Storage Block/Unblock
WSD-PRINT On/Off
Enhanced WSD On/Off
EnhancedWSD (SSL) On/Off
IPP On/Off