7-84 Using the Operation Panel
Adjust/Maintenance (Adjust/Maintenance
selection/setting)
Adjust/Maintenance is used to adjust the print quality and to carry out
printer maintenance.
The options available in Adjust/Maintenance are as follows:
• Restart Printer
• Service (for maintenance)
IMPORTANT Service is primarily a menu used by service person-
nel for maintenance work. There is no need for customers to use this
menu.
1
Press [MENU].
2
Press or repeatedly until Adjust/Maintenance > appears.
Restart Printer
The procedure described below resets the printer’s temporary
conditions, such as the current page orientation, font, etc., set by
commands to their default values. Downloaded fonts and macros are
deleted from the printer’s memory.
1
Press while Adjust/Maintenance > is displayed.
2
Press or repeatedly until >Restart Printer appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. Self test appears while the printer is resetting
itself, followed by Please wait and then Ready.
To Next Page
Loading...
