7-34 Using the Operation Panel
5
Press [OK]. A blinking question mark (?) appears.
6
Press or to increase or decrease the value at the blinking
cursor. The character pitch can be set 0.44 and 99.99 characters per
inch, in 0.01 character-per-inch increments. Use or to move the
cursor right and left.
7
When the desired size is displayed, press [OK].
8
Press [MENU]. The display returns to Ready.
Code Set (Setting the code set)
You can change the character code set. Available character code sets
vary depending on the current font. (The default is IBM PC-8.)
1
Press while Print Settings > is displayed.
2
Press or repeatedly until >Code Set appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Press or until the desired character code set appears.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
To Next Page
Loading...
