Using the Operation Panel 7-25
4
Press or to display the desired paper thickness. The display
changes as shown below. For details of the default setting for each
paper type, refer to Paper Specifications on page 2-2.
Light
Normal 1
Normal 2
Normal 3
Heavy 1
Heavy 2
Heavy 3
Extra Heavy
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Duplex Path (Setting the duplex path)
1
Display the custom paper type (refer to Type Adjust (Creating
custom paper type) on page 7-24) and press .
2
Press or repeatedly until >>Duplex Path appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select Enable or Disable using or . For details of the default
setting for each paper type, refer to Paper Specifications on page 2-
2.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
The custom paper type setting is completed.
Reset Type Adjust (Resetting the custom paper type)
Reset all the custom paper type that was set in Type Adjust (Creating
custom paper type) on page 7-24.
1
Press while Paper Settings > is displayed.
2
Press or repeatedly until >Reset Type Adjust appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. All customized paper types will be reset to the
default. The display returns to Ready.