7-64 Using the Operation Panel
2
Press [OK]. The message display shows a blinking cursor (_).
3
Press or to increase or decrease the value at the blinking cursor
and set the desired time. The time must be set between 005 and 495
seconds, in 5-second increments. Use and to move the cursor
right and left.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Low Power Timer (Low Power Mode timer timeout time)
You can adjust the length of time the printer waits before entering Low
Power Mode in the absence of a print job.
The printer reverts to normal operation mode when the printer receives a
print job or [GO] is pressed on the operation panel. The default time is
1 minute.
1
After entering the administrator ID and password, press or
repeatedly until >>Low Power Timer appears.
2
To change the timeout time, press [OK]. A blinking cursor (_)
appears.
3
Press or to increase or decrease the value at the blinking cursor
and set the desired time. The timer can be set between 1 and
120 min (for Europe) or 1 and 240 min (except for Europe). Use
and to move the cursor right and left.
4
Press [OK].
5
Press [MENU]. The display returns to Ready.
Sleep Timer (Sleep timer timeout time)
You can adjust the length of time the printer waits before entering Auto
Sleep in the absence of data.
The printer reverts to normal operation mode when the printer receives a
print job, or [GO] is pressed on the operation panel. The default time is
15 minutes (for Europe) and 1 minute (except for Europe).
1
After entering the administrator ID and password, press or
repeatedly until >>Sleep Timer appears.
2
To change the timeout time, press [OK]. A blinking cursor (_)
appears.
3
Press or to increase or decrease the value at the blinking cursor
and set the desired time. The timer can be set between 1 and
120 min (for Europe) or 1 and 240 min (except for Europe). Use
and to move the cursor right and left.
4
Press [OK].
To Next Page
Loading...
