Kyocera ECOSYS P2135dn - Page 176

7-70 Using the Operation Panel
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using  or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
USB Cable (Setting for entering energy-saving mode when
connected to a USB)
This sets whether or not the machine enters sleep mode when
connected to a USB.
1 After entering the administrator ID and password, press  or 
repeatedly until >>USB Cable appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using  or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
RAM Disk (Setting for entering energy-saving mode when using the
RAM disk)
This sets whether or not the machine enters sleep mode when using the
RAM disk.
1 After entering the administrator ID and password, press  or 
repeatedly until >>RAM Disk appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using  or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
>>Network
? On
>>USB Cable
? On
>>RAM Disk
? On