10-22
Troubleshooting > Troubleshooting
S
T
Message Checkpoints Corrective Actions
Reference
Page
SD card error.
Press [OK].
― An error has occurred on the SD
card. Job is canceled. Select [OK].
The error cord is as follows.
04: Insufficient sp
ace on the SD
card to complete this operation.
Move data or delete unneeded data.
―
SSD error.
Press [OK].
― An error has occurred on SSD. Job
is canceled. Select [End].
The error cords are as follows.
01: The amount of dat
a that can be
saved at once has been exceeded.
Turn the power OFF/ON. If the error
still occurs, divide the file into
smaller files. If the error occurs after
the file is divided, the specified file
may be damaged. Delete the file.
04: Insufficient sp
ace on SSD to
complete this operation. Move data
or delete unneeded data.
―
Message Checkpoints Corrective Actions
Reference
Page
The device cannot be
connected because
allowed connections
would be exceeded.
Are three handheld devices
connected simultaneously?
Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
page 7-5
The file name already
exists.
You cannot copy.
― Copying is not possible because
data with the same file name exists
at the destination. Delete the data
with the same file name at the
destination before copying.
page 5-10
The user name is not
registered.
― The login user name entered is not
registered. Check the login user
name.
page 9-3
The waste toner box is
full.
Is the waste toner box full? Replace the waste toner box. page 10-9
The waste toner box is
improperly installed.
― The waste toner box is not installed
correctly. Set it correctly.
page 10-9
This account ID is
already registered.
― The account ID set has already
been registered. Register a different
account ID.
page 9-17
This login user name
already registered.
― The changed login user name has
already been registered. Set a
different login user name.
page 9-3
To Next Page
Loading...
