2-45
Installing and Setting up the Machine > Command Center RX
E-mail Settings
By configuring the SMTP settings, it is possible to send E-mail notices when jobs have been completed.
To use this function, this machin
e must be connected to a mail server using the SMTP protocol.
In addition, configure the following.
•SMTP settings
Item: "SMTP Protocol" and "SM
TP Server Name" in "SMTP"
• The sender address when the machine sends E-mails
Item: "Sender Address" in "E-mail Send Settings"
• The setting to limit the
size of E-mails
Item: "E-mail Size Limit" in "E-mail Send Settings
"
The procedure for specifying the
SMTP settings is explained below.
1
Display the screen.
Display the SMTP Protocol screen.
1 La
unch your Web browser.
2 In the a
ddress or location bar, enter the machine's IP address or the host name.
Print the status page to check the machine's IP address and the host name.
[Menu] key > [▲]
[▼] key > [Report] > [OK] key > [▲] [▼] key > [Report Print] > [OK] key >
[▲]
[▼] key > [Status Page] > [OK] key > [Yes]
3 Log in with administrator privileges.
The factory default setting for the default user with administrator privileges is shown below. (Upper
case and lower case letters are distinguished (case sensitive).)
Login User Name: Admin
Login Password: Admin
To Next Page
Loading...
