2-25
Installing and Setting up the Machine > Energy Saver function
Energy Saver function
If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode, which
minimizes power consumption.
Sleep and Auto Sleep
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To resume, perform the follow
ing actions.
• Select the [OK]
key.
The machine will be ready to operate within 25 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Follow the steps below to set t
he sleep timer for the machine to go into sleep mode when not in use.
1
Display the screen.
[Menu] key > [▲] [] key > [Device Common] > [OK] key > [▲] [] key > [Timer Setting] >
[OK] key > [▲] [] key > [Sleep T
imer] > [OK] key
2
Set the Sleep time.
1 Enter the Sleep time.
2 Se
lect the [OK] key.
Status (Sleep Level Set.)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card cannot
be recognized.
For more information on Status, r
efer to the following:
Status (page 8-33)
If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disab
led, the user authentication screen appears. Enter a login user name and
password, and select [Login].
The factory default login user nam
e and login password are set as shown below.
Login User Name: 6000
Login Password: 6000
Use the numeric keys or select the [▲] or [▼] key to enter a number.