2-2 Printing Operation
Changing Network Interface Parameters
This printer supports TCP/IP, TCP/IP (IPv6), IPP, SSL Server and the
IPSec protocols and Security Level.
The table below shows the items required for each of the settings.
Configure the printer's network parameters as appropriate for your PC
and your network environment.
For details of the procedure, refer to the Using the Operation Panel on
page 4-1.
Note
When Command Center RX is used, network
parameters and security settings can be conveniently
changed and checked from your PC. For more information,
refer to Command Center RX User Guide.
If the optional IB-50 or IB-51 is installed then NetWare and
AppleTalk settings are possible. For details, refer to Optional
Network (Optional Network settings) on page 4-73.
Menu Submenu Setting
Network TCP/IP
Settings
TCP/IP On/Off
IPv4
Setting
DHCP On/Off
Auto-IP On/Off
IP Address IP address
Subnet Mask IP address
Default
Gateway
IP address
Bonjour On/Off
IPv6
Setting
TCP/IP(IPv6) On/Off
RA(Sateless) On/Off
DHCPv6 On/Off
Security Network
Security
WSD-PRINT On/Off
Enhanced WSD On/Off
EnhancedWSD (SSL) On/Off
IPP On/Off
SSL
Setting
SSL On/Off
IPP over SSL On/Off
HTTPS On/Off
IPSec On/Off
LAN Interface Auto/10BASE-Half/
10BASE-Full/
100BASE-Half/
100BASE-Full/
1000BASE-T