1-1-2
FS-9120DN/9520DN
(14) Image is partly missing. ................................................................................................................ 1-5-33
(15) Fusing is poor. .............................................................................................................................. 1-5-34
(16) Image is out of focus. ................................................................................................................... 1-5-34
(17) Image is not square. ..................................................................................................................... 1-5-34
1-5-4 Electrical problems ............................................................................................................................. 1-5-35
(1) The machine does not operate when the power switch is turned on............................................ 1-5-35
(2) The drive motor does not operate (C2000). ................................................................................. 1-5-35
(3) The paper feed motor does not operate (C2500). ........................................................................ 1-5-35
(4) The eject motor does not operate. ................................................................................................ 1-5-35
(5) The upper lift motor does not operate (C1010). ........................................................................... 1-5-36
(6) The lower lift motor does not operate (C1020). ............................................................................ 1-5-36
(7) Cooling fan motor 1 does not operate. ......................................................................................... 1-5-36
(8) Cooling fan motor 2 does not operate. ......................................................................................... 1-5-36
(9) Cooling fan motor 3 does not operate. ......................................................................................... 1-5-36
(10) Cooling fan motor 4 does not operate. ......................................................................................... 1-5-36
(11) Cooling fan motor 5 does not operate. ......................................................................................... 1-5-36
(12) Cooling fan motor 6 does not operate. ......................................................................................... 1-5-37
(13) Cooling fan motor 7 does not operate. ......................................................................................... 1-5-37
(14) The upper paper feed clutch does not operate............................................................................. 1-5-37
(15) The lower paper feed clutch does not operate. ............................................................................ 1-5-37
(16) Feed clutch 1 does not operate. ................................................................................................... 1-5-37
(17) Feed clutch 2 does not operate. ................................................................................................... 1-5-37
(18) Feed clutch 3 does not operate. ................................................................................................... 1-5-37
(19) The MP paper feed clutch does not operate. ............................................................................... 1-5-38
(20) The MP feed clutch does not operate. .......................................................................................... 1-5-38
(21) The registration clutch does not operate. ..................................................................................... 1-5-38
(22) The feedshift solenoid does not operate. ..................................................................................... 1-5-38
(23) The toner feed solenoid does not operate. ................................................................................... 1-5-38
(24) The cleaning lamp does not turn on. ............................................................................................ 1-5-38
(25) The fuser heater does not turn on (C6000). ................................................................................. 1-5-39
(26) The fuser heater does not turn off. ............................................................................................... 1-5-39
(27) Main charging is not performed. ................................................................................................... 1-5-39
(28) Transfer charging is not performed. ............................................................................................. 1-5-39
(29) No developing bias is output. ....................................................................................................... 1-5-39
(30) The message requesting paper to be loaded is shown when paper is present
in the upper cassette. ................................................................................................................... 1-5-39
(31) The message requesting paper to be loaded is shown when paper is present
in the lower cassette. .................................................................................................................... 1-5-39
(32) The message requesting paper to be loaded is shown when paper is present
on the MP tray. ............................................................................................................................. 1-5-40
(33) The size of paper in the upper cassette is not displayed correctly. .............................................. 1-5-40
(34) The size of paper in the lower cassette is not displayed correctly................................................ 1-5-40
(35) The printing width of the paper on the MP tray is not detected correctly...................................... 1-5-40
(36) A paper jam in the paper feed, paper conveying or fuser section is indicated
when the power switch is turned on. ............................................................................................ 1-5-41
(37) The message requesting covers to be closed is displayed when the front cover
and conveying cover are closed. .................................................................................................. 1-5-41
(38) Others. .......................................................................................................................................... 1-5-41
1-5-5 Mechanical problems ......................................................................................................................... 1-5-42
(1) No primary paper feed. ................................................................................................................. 1-5-42
(2) No secondary paper feed. ............................................................................................................ 1-5-42
(3) Skewed paper feed. ...................................................................................................................... 1-5-42
(4) Multiple sheets of paper are fed at one time. ................................................................................. 1-5-42
(5) Paper jams. .................................................................................................................................. 1-5-42
(6) Toner drops on the paper conveying path. ................................................................................... 1-5-42
(7) Abnormal noise is heard. .............................................................................................................. 1-5-43
To Next Page
Loading...
Need help?
General
