Kyocera FS-C2026MFP

Default Setting (System Menu)
8-166
IPSec Setting
Make this setting when you use IPSec. The default setting is On and that of Rule Setting is also Off.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and press the OK key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in, and press [Login] (the Right
Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the U or V key to select [IPSec].
6 Press the OK key. IPSec appears.
7 Press the U or V key to select [On] or [Off].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
4 WSD-SCAN
5 WSD-PRINT
*********************
[ Exit ]
6 IPSec
IPSec: a b
*********************
2 On
1 *Off